How to use Gskyer Telescope

Following the given steps to use the Gskyer telescope:

Remove the tripod’s legs.
To keep the extended legs in place, use a tightening screw.
Spread out the other two legs in the same manner.
To put the accessory tray together, start by aligning the notches.
Then turn the knob clockwise to lock the tray tabs into the tripod brackets.
Pull the thread cover out of the way.
Combine the AZ Altazimuth Mount with the handle.
Place the body tube in the appropriate location
Tighten the set screw on the body tube.
Insert the base of the finderscope into the body tube.
Tighten the screw on the base of the finderscope.
Slide the finderscope into the hole on the base by lowering the metal extending screw.
Adjust the three screws on the base to center the finderscope in the hole.
In the focuser, place the zenith mirror.
On the zenith screw, tighten the screw.
On the zenith screw, tighten the screw.
In the zenith mirror, place a 25mm eyepiece.
In the zenith mirror, place a 10mm eyepiece.
In the zenith mirror, place a 5mm eyepiece.
3X Barlow lens installation
In a 3X Barlow lens, place a 25mm eyepiece.
In a 3X Barlow lens, place a 10mm eyepiece.
In a 3X Barlow lens, place a 5mm eyepiece.
5n m 18. Remove the objective lens cover.
In the zenith mirror, place a 5mm eyepiece.
To clear the field, turn the focuser wheel. 3X LOW LENS 19. 3X Barlow lens installation
Now you can use your telescope.

https://manuals.plus/gskyer/gskyer-telescope-70mm-aperture-400mm-az-mount-astronomical-refracting-telescope-complete-features-owners-manual#ixzz7qWAqU88K